How to connect plastic pipes correctly?

[zihadhosenjm40]

Thirdly, evaluate the material of the device coating and its components. The ideal coating today is a Teflon heat-resistant coating, which maintains the temperature of the device and does not allow it to go beyond the permissible limits. Do not choose devices with an unprotected metal or plastic coating - these materials are subject to destruction.

Safety and ease of use should be a priority when choosing a czech republic mobile database welder. If you don't have one in your kit, be sure to purchase gloves and a pipe cutter to make the soldering process easier and to protect yourself from possible injuries and burns.

To carry out welding work using a special device for plastic pipes, you need to know a few simple rules to protect yourself from possible mistakes.

Connect to the network. It is necessary to place the device on the stand, usually included in the kit, and leave it for 2-5 minutes until the control lamps go out. This is necessary for the device to heat up to a certain temperature. During this process, you can attach the appropriate attachment.
Set the temperature mode. If you have a thermostat, you can select the optimal soldering temperature. Sometimes, plastic pipe manufacturers may use reinforcing additives in production that either increase or decrease the material's refractoriness.
Take care of your safety. The metal surface of the nozzle is very hot when you start working. Contact with skin may cause a severe burn. Use heat-protective gloves when working with the welding machine.
Make preliminary calculations. Measure the distance that one pipe will enter another at the time of soldering. It is best to use a pencil or marker that can be easily erased. It is worth measuring depending on the diameter of the pipes. For example, with a diameter of 20 mm, it is worth measuring about 13-15 mm of length.
Warm up both parts before soldering. When heating up one of the parts of the pipes to be connected, the desired tightness is not achieved. It is advisable to hold each of the plastic parts on the soldering iron nozzle for 5 to 10 seconds.
For more details, watch the video: